Rinnai Temperature Controller Not Working

Water is not hot enough.

Rinnai temperature controller not working.

If flame drops on stove this shows it is possibly a gas supply issue is there enough water flowing. It did not blow the new fuses. Water flow might be reduced when the water filter or fixture aerator are clogged. Controllers enable you to simply set your desired hot water temperature turn on the hot tap and enjoy no more mixing hot and cold.

This information can be found under the front cover in the plastic holder. You can try unplugging the servo and see if display comes back and if it does replace the water flow control valve. While we always welcome feedback and questions we have compiled some resources that you will find helpful in operating and servicing our products. Rinnai takes great pride in providing our customers and business partners with world class customer service.

Rinnai r53 contoller not working. November 2015 in domestic hot water. The water servo may have a short thus taking out the display. Is the unit working.

The enhanced control r mobile app with smart home technology integrates more than 20 voice commands allowing on demand voice activation of the recirculation system and temperature control. Increase the temperature to approximately 125 130 f or higher if needed. I talked to the helpdesk and he advised that the old controllers may work initially but could stop working later. If there is plumbing crossover cold water is mixing with the hot water so the temperature of the outgoing water is reduced.

Water temperature is set too low. Water controllers to make the most of your rinnai continuous flow hot water experience we suggest installing of at least one of our rinnai water controllers. Trying to re use the old controllers would not damage the hot water unit but it could damage the controllers eventually. It is better to try the mc 91 1a and i can confirm it works with the new hot water unit infinity 16.

Paring with amazon alexa google home and samsung smartthings is possible only with rinnai tankless water heaters. If the manifold pressures are not properly set the temperature range for this senor may be too low causing a code 10. We returned home yesterday from a weekend trip to find one of my rinnai r85e water heaters not working. The control pad was dead so i took the front cover off of the unit and found both 3 amp fuses had blown.

If a controller is fitted check that it is on also check gas supply turn gas stove top on then turn hot water tap on. I replaced both fuses i did check continuity on the new fuses and the unit still does nothing.