Rigid Foam Above The Roof Sheathing

Over the foam you will need something to nail the roofing to usually a solid sheet of plywood or osb.

Rigid foam above the roof sheathing.

Apply a continuous air control membrane to existing roof sheathing or tape all joints between roof sheathing panels with an acrylic or butyl adhesive. The nailbase panels are installed with long screws that have flat heads. Johns manville polyiso foam sheathing insulation boards provide a continuous layer of insulation to reduce thermal bridging and improve energy efficiency. Go back and check out photograph 10.

Installing rigid foam insulation on top of roof sheathing is a great option for commercial buildings and homes with limited space. This was then foamed to complete the air seal. If the sheathing is on the exterior of the foam then drying isn t a concern because interior vapor will never reach the sheathing and the sheathing will always dry to the exterior especially with any rainscreen. Many homes in more urban areas or other places with dense populations are opting for this method because they can better optimize space.

The purpose of the requirement that rigid foam installed above roof sheathing meet certain minimum r values is to ensure that the roof sheathing stays warm enough during the winter to avoid moisture accumulation and possible sheathing rot. Start at the bottom of the roof and place the first piece of rigid foam insulation against the metal flashing starting at the center line. Benefits of rigid foam on top of sheathing. How to retrofit a roof to a high performance roof with insulating sheathing above the roof deck plus cavity insulation in roof framing remove existing roofing and non adhered roof underlayment.

Nail it around the edges with roofing nails. Rigid foam sheathing is a form of insulation continuous insulation to be exact that s applied to the exterior of the building. On the front of the roof edges the original roof deck sheathing was cut back flush with the wall and the fully adhered membrane folded down around the rafter tails to catch the wall water control layer and air control layer. Rigid insulation sheathing is made of a rigid plastic foam that is typically sold in 4 8 or 4 10 foot boards.